Pages

Monday, February 11, 2013

Jointing the Top

So here is my procedure for jointing the top, the back is done the same..

Clean up the edges on a shooting board using a jack plane, in this case a nice low angle jack from Lee Valley. - great plane.


I can get the joint perfect using the hand plane but I often times take more time than I would like chasing the joint around. So I finish the edge with a few passes of a 24" level with 220 PSA Sand paper. I find it works better for me this way.



Then the joint is glued together using original Titebond and held fast using a simple wedge jig, again simple and works great.


No comments:

Post a Comment